D its carbonyl content measured as detailed above.Measurement of Plasma VWF:ag, VWF:act, and ADAMTS13 LevelBlood samples were collected in 3.8 citrate and rapidly stored at 280uC. VWF:ag in plasma was measured using HemosIL von Willebrand Factor Antigen latex immunoassay kits (HemosIL, Instrumentation Laboratory, Milano, Italy) with ACL TOP coagulation system analyzers (Instrumentation Laboratory, Milano, Italy). VWF activity (VWF:act) was measured with a ristocetin cofactor assay using lyophilized platelets (BC VWF reagent kit, Siemens, Milano, Italy) with a BCS coagulation system analyzer (Siemens). The 1531364 lower limit of normal level for both VWF:ag and VWF:act is 54 IU/dL. The validated normal range of the 23115181 VWF:act/VWF:ag ratio (n. 200 normal donors) was from 0.71 to 1.35, with mean at 0.9860.34. ADAMTS13 protease activity (expressed as Methyl linolenate percentage of normal) was measured by a fluorescence resonance energy transfer based assay using a VWF86 amino-acid peptide substrate (Instrumentation Laboratory, Milano, Italy) in a Varian Eclipse spectrofluorimeter. ADAMTS-13 antigen was measured by an EIA assayFigure 2. Statistical comparison between calculated VWFbound-carbonyl levels in type 2 diabetic patients with and without microangiopathic complications (renal and retinal). According to Mann-Whitney test, VWF-bound carbonyls had higher values in microangiopathic subjects than in non macroangiopathic diabetics (mean values 6 SD: 92622 vs 3568 pmol/mg, respectively, p = 0.022). doi:10.1371/journal.pone.0055396.gOxidized von Willebrand Factor and DiabetesUSA). The quantitative evaluation of UL-VWFmultimers, was performed using the method proposed by Udvardy et al. [14]. ULVWF was defined as high molecular weight multimers (.10000 kDa), not observed in multimer pattern of plasma VWF from healthy subject. The identification of these high molecular weight forms was also facilitated by comparing the electrophoretic pattern of recombinant VWF, a generous gift of Dr. Friedrich Scheiflinger (Baxter Innovations GmbH, Vienna, Austria), which does not contain any proteolyzed VWF band and includes multimers with molecular weight .10000 kDa. In particular, the amount of UL-VWFmultimers was expressed with the MMW parameter [14]. Digital images of the membranes were obtained by a ChemiDoc MP calibrated densitometer and processed by its QuantityOne software (Bio-Rad Laboratories, Richmond, CA, USA). The background density of the membrane image was subtracted coarsely in a protein-free area. The resulting density (RD) of each VWF peak against relative mobility (RM) data was used for subsequent computations. The MMW parameter assesses the degree of multimerization. First, a curve of RD against RM values was constructed. The upper 25 of the total area under the densitogram peaks was calculated. The molecular weight corresponding to the lower boundary of the 25 of densitometric area was used to MedChemExpress Calyculin A calculate the MMW parameter. The molecular weight corresponding to this RM (MMW) was estimated based on the correlation of the VWF peaks mobility and their molecular weight, estimated as 500 kDa for a homodimer unit corresponding to the lowest band at the bottom of the gel in each lane [14].Hydrolysis by ADAMTS-13 of VWF Purified from Clinical SamplesVon Willebrand factor, purified as detailed above from clinical samples, was used in these functional experiments. In particular, 2 fractions with the highest VWF-bound carbonyls (380 and 230 pmol/mg, respectively) were pooled.D its carbonyl content measured as detailed above.Measurement of Plasma VWF:ag, VWF:act, and ADAMTS13 LevelBlood samples were collected in 3.8 citrate and rapidly stored at 280uC. VWF:ag in plasma was measured using HemosIL von Willebrand Factor Antigen latex immunoassay kits (HemosIL, Instrumentation Laboratory, Milano, Italy) with ACL TOP coagulation system analyzers (Instrumentation Laboratory, Milano, Italy). VWF activity (VWF:act) was measured with a ristocetin cofactor assay using lyophilized platelets (BC VWF reagent kit, Siemens, Milano, Italy) with a BCS coagulation system analyzer (Siemens). The 1531364 lower limit of normal level for both VWF:ag and VWF:act is 54 IU/dL. The validated normal range of the 23115181 VWF:act/VWF:ag ratio (n. 200 normal donors) was from 0.71 to 1.35, with mean at 0.9860.34. ADAMTS13 protease activity (expressed as percentage of normal) was measured by a fluorescence resonance energy transfer based assay using a VWF86 amino-acid peptide substrate (Instrumentation Laboratory, Milano, Italy) in a Varian Eclipse spectrofluorimeter. ADAMTS-13 antigen was measured by an EIA assayFigure 2. Statistical comparison between calculated VWFbound-carbonyl levels in type 2 diabetic patients with and without microangiopathic complications (renal and retinal). According to Mann-Whitney test, VWF-bound carbonyls had higher values in microangiopathic subjects than in non macroangiopathic diabetics (mean values 6 SD: 92622 vs 3568 pmol/mg, respectively, p = 0.022). doi:10.1371/journal.pone.0055396.gOxidized von Willebrand Factor and DiabetesUSA). The quantitative evaluation of UL-VWFmultimers, was performed using the method proposed by Udvardy et al. [14]. ULVWF was defined as high molecular weight multimers (.10000 kDa), not observed in multimer pattern of plasma VWF from healthy subject. The identification of these high molecular weight forms was also facilitated by comparing the electrophoretic pattern of recombinant VWF, a generous gift of Dr. Friedrich Scheiflinger (Baxter Innovations GmbH, Vienna, Austria), which does not contain any proteolyzed VWF band and includes multimers with molecular weight .10000 kDa. In particular, the amount of UL-VWFmultimers was expressed with the MMW parameter [14]. Digital images of the membranes were obtained by a ChemiDoc MP calibrated densitometer and processed by its QuantityOne software (Bio-Rad Laboratories, Richmond, CA, USA). The background density of the membrane image was subtracted coarsely in a protein-free area. The resulting density (RD) of each VWF peak against relative mobility (RM) data was used for subsequent computations. The MMW parameter assesses the degree of multimerization. First, a curve of RD against RM values was constructed. The upper 25 of the total area under the densitogram peaks was calculated. The molecular weight corresponding to the lower boundary of the 25 of densitometric area was used to calculate the MMW parameter. The molecular weight corresponding to this RM (MMW) was estimated based on the correlation of the VWF peaks mobility and their molecular weight, estimated as 500 kDa for a homodimer unit corresponding to the lowest band at the bottom of the gel in each lane [14].Hydrolysis by ADAMTS-13 of VWF Purified from Clinical SamplesVon Willebrand factor, purified as detailed above from clinical samples, was used in these functional experiments. In particular, 2 fractions with the highest VWF-bound carbonyls (380 and 230 pmol/mg, respectively) were pooled.
Posted inUncategorized